And Consulting Private Limited
And Consulting Private Limited
ETAP studies and power system analysis services in India help industrial plants, utilities, data centres and infrastructure teams verify electrical safety, reliability and system performance. Elion develops and validates electrical network models for load-flow, short-circuit, relay and protection coordination, arc-flash, harmonic, motor-starting and transient-stability analysis.
Each engagement documents the available input data, study assumptions, applicable IS, IEC, IEEE and CEA requirements, calculated results and practical recommendations. Elion has delivered independent engineering audit and safety services since 2010; the company-wide record of 30,000+ audits refers to Elion’s overall audit experience and is not a count of ETAP studies.
Elion performs the following ETAP-based power system studies according to the agreed project scope:
Related Elion services include Power Quality Analysis, Transient Surge Analysis and Single Line Diagram (SLD) preparation and verification.
Depending on the agreed scope and available data, deliverables may include:
ETAP study cost depends on: which studies are needed (a single load-flow analysis vs. a full suite of load flow, short circuit, relay coordination, and arc flash study), system size and complexity (number of buses, transformers, and feeders), whether on-site data collection is required, and turnaround time. Request a fixed-fee quote with your single-line diagram and system details.
Improve your facility’s electrical safety, reliability and protection performance with a clearly scoped ETAP study. Request a quote or email [email protected] with your latest single-line diagram, study objectives and available equipment data.
ETAP studies use a digital electrical-network model to analyse normal operation, fault conditions, protection performance, equipment starting and selected system disturbances.
Load flow, short circuit, relay coordination, arc flash, and harmonic analysis.
They enhance safety, reliability, and compliance of electrical systems.
Yes, to identify voltage drops and optimize loading.
Yes, for fault level calculation.
Calculation of relay settings to ensure selective protection.
Yes, including incident energy calculation and PPE labeling.
SLDs, equipment ratings, relay data, and operational data.
They support compliance with CEA and safety regulations.
Every 3-5 years or after major system changes.
You will receive a comprehensive technical report including system modeling results, fault calculations, risk assessment, protection recommendations, and compliance references.
An electrical audit identifies visible issues and inefficiencies, while ETAP provides detailed simulation-based analysis of system performance and fault behavior.